Manufacturing is looking good in 2018

SigmaTEK Systems, creators of the powerful nesting software, SigmaNEST, reported a record-breaking Fabtech Expo this week. “This trade show is always a strong predictor of where the economy is going. Manufacturing investment acts as a leading indicator for growth, and this year’s attendees were ready to invest, both in

Comments Off on Manufacturing is looking good in 2018

CMTS 2017: Visit Us

CMTS 2017: Visit Us SigmaTEK will be visiting the Canadian Manufacturing Technology Show at The International Centre (Halls 1-4) in Mississauga, Canada from September 25th through September 28th. We will be joined by over 700+ manufacturing industry professionals who will showcase more than 3,000,000 lbs of manufacturing equipment and technology,

Comments Off on CMTS 2017: Visit Us

SigmaTEK To Showcase Router Capabilities at AWFS

The SigmaTEK team heads out to Las Vegas this week for the annual AWFS show at the Las Vegas Convention Center. SigmaTEK associates plan to demonstrate SigmaNEST's wide range of software solutions and expertise. We are located at Booth 10047 to discuss specific customer challenges

Comments Off on SigmaTEK To Showcase Router Capabilities at AWFS

By continuing to use the site, you agree to the use of cookies. More Information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close